From the Loftsmith community

Horse sucker mold master

For making your own horse lollipops at home. Two horses sit side by side in a shallow tray, each with a narrow channel running down from its belly for the stick. Change the horse size, candy thickness or number of horses to suit your batch.

1 part · 62 g · 194 × 100 × 16 mm

Shallow rectangular tray holding two raised horse shapes, each with a thin stick channel below
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • mold-master · PLA

    Print flat. Sand and seal the horses, because silicone copies every layer line.

Print settings

Layer height
0.12 mm for smooth horses
Walls
2
Infill
15%
Supports
None

Hardware

  • Food-safe platinum silicone, about 230 ml · Rated for hot sugar, around 150 °C or more

Assembly

  1. Sand and seal the horses, then add a thin coat of mold release.
  2. Pour mixed silicone into the tray up to the rim and let it cure.
  3. Peel the silicone out, lay in sticks, and pour in hot candy.

Good to know

  • This is a single-sided (domed relief) mold, not a full 3D two-half horse. I can make a two-half version if you want that.
  • The Use it demold animation was only partly checked, and I haven't test-printed or test-cast anything.
  • The silicone amount and candy weight are estimates.
I printed this Remix

Comments