From the Loftsmith community

Z900 mirror riser bracket

Gets your Z900 mirrors out past your elbows so you can see the road instead of your own arms. Each side is a small two-hole plate with a trapped nut for the M10 mirror stem. Change the outward offset and sweep back angle to find your view.

2 parts · 14 g · 244 × 37 × 13 mm

Pair of small dark two-hole plates, each with a long thin mirror stem tilting up and out from one end
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • bracket-left · PLA · Flat, nut-pocket side down

    Standard right-hand M10×1.25

  • bracket-right · PLA · Flat, nut-pocket side down

    Use a left-hand (reverse) M10×1.25 bolt and nut

Print settings

Layer height
0.2 mm
Walls
4
Infill
25% gyroid
Supports
None. The only overhang is the 17 mm hex nut ceiling, which is a short bridge. Slow the bridge speed, or add a support blocker.

Hardware

  • 2 × M10×1.25 bolt with washer, about 25 mm long, left-hand on the right side · Check the length against your perch boss.
  • 2 × M10×1.25 hex nut (left-hand on the right side) · The trapped nut. It is 17 mm across the flats, so change the nut wrench-size slider if yours differs.
  • 2 × M10×1.25 lock nut for the mirror stem · Optional but recommended.

Good to know

  • I could not verify the Z900's thread and boss sizes. Measure your perch boss and mirror stem, then adjust the sliders.
  • The build report flags about 9% overhang. It comes mainly from the nut-pocket ceiling, which prints as a bridge. I did not rebuild to remove it.
  • PLA softens at about 55 °C and could creep in summer sun. Print in PETG or ASA for real riding.
  • The strength checks are estimates, not tests. Fit both brackets on the bench first, and check mirror clearance against the clutch and brake levers.

Comments