From the Loftsmith community

Pin & hole tolerance test

Find out how loose or tight your printer really makes things before you commit to a big print. A flat plate has rows of round holes, and loose pins in four widths drop into them. Try each gap, then see which one gives you a fit you like.

13 parts · 5 g · 73 × 36 × 5 mm

by Piotr

Flat grey plate with rows of round holes in four sizes, plus loose orange pegs beside it
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • plate · PLA (SUNLU PLA+ 2.0) · Flat, labels facing up

    Columns = pin size in mm, rows = total clearance in mm

  • pin 2 mm ×3 · PLA (SUNLU PLA+ 2.0) · Standing upright, chamfer down
  • pin 3 mm ×3 · PLA (SUNLU PLA+ 2.0) · Standing upright, chamfer down
  • pin 4 mm ×3 · PLA (SUNLU PLA+ 2.0) · Standing upright, chamfer down
  • pin 6 mm ×3 · PLA (SUNLU PLA+ 2.0) · Standing upright, chamfer down

Print settings

Layer height
0.20 mm
Walls
2
Infill
15%
Supports
None
Notes
Bambu Studio standard PLA profile; leave elephant-foot compensation at its default so the result matches your usual parts. No brim, because it would hide the pin chamfer.

Assembly

  1. Let the plate cool, then pop the pins off the bed.
  2. Push each pin into the three holes in its column from the top. Try both faces, because the bed side is often a bit tighter.
  3. Write down the smallest clearance that slides freely for each size, then use that in CAD for that hole size.

Good to know

  • The 2 mm pins only touch the bed over a tiny area because of the chamfer. They're short enough to stay put, but if one comes loose, print them a little slower or clean the plate first.
  • Your results only hold for this filament, profile and the default elephant-foot setting. Changing any of those can shift the fit by about 0.1 mm.

Comments