From the Loftsmith community

Ingranaggio con parte nera

A small toothed gear with a hollow hub that rises up from the middle, plus a flat black arm with a ring on one end that slips over the hub. Handy when you need to turn a shaft or pointer from a gear. Change the tooth count or the hub bore to suit your shaft.

2 parts · 7 g · 63 × 91 × 23 mm

by Stefano

Orange toothed gear with a tall hollow hub, beside a black ring-ended arm
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • ghiera · PLA · In piano, senza supporti

Print settings

Layer height
0.12 mm
Walls
3
Infill
20%
Supports
Nessuno

Good to know

  • La punta di 0,17 mm è più sottile dell'ugello: la stampante la arrotonda un po'. Se vuoi punte più robuste abbassa il cursore a 0,5.
  • Il controllo segnala ancora delle righe sottili sui denti: sono le facce dei fianchi molto inclinati. Non sono riuscito a eliminarle del tutto, guarda se si vedono nella stampa.
  • I valori che avevi messo (foro 31, spessore 2) lasciano una parete troppo sottile: con quel foro il diametro del fondo dente non basta.

Comments