From the Loftsmith community

2" square tube spacer for 1-1/4" conduit

Centers a round conduit inside a square tube so it stops rattling around. The block slips into the tube and has a round opening that the conduit passes through. Four small holes sit in the corners. Change the tube width and conduit diameter to match yours.

1 part · 17 g · 46 × 46 × 40 mm

Short square block with a large round hole and four small corner holes, shown inside a square tube around a pipe
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • spacer · PLA · Flat on either end, no supports

Print settings

Layer height
0.2 mm
Walls
4
Infill
100%
Supports
None

Good to know

  • Measure your tube's inside width and set it on the Tube inside width slider. Tube walls vary, and the fit gap is only 0.5 mm total.
  • Fit hasn't been tested on a real tube. Print the spacer at 10 mm long first to check it.
I printed this Remix

Comments