From the Loftsmith community

5/8" drill grid jig, 2" pitch

Drills a neat grid of 5/8" holes in a sheet without marking out every one. Peg the flat plate through the last hole you drilled, line up the next numbered guide hole, and go. Change the hole spacing or the sheet thickness to match your own project.

5 parts · 73 g · 205 × 89 × 28 mm

Flat L-shaped plate with four numbered holes, three with dark inserts, resting on a thin sheet with a peg through it
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • drill jig · PLA · Top face down, no supports
  • top-edge stop · PLA · Flat, as modeled

    Pegs press into the jig's underside. Use it only for the very first row, then pull it off.

  • pin ×3 · PLA · Head down

    Drop the pins through holes 1 and 2 into the last two holes drilled, and through the row-step hole into the first hole of the row above.

Print settings

Layer height
0.2 mm
Walls
3
Infill
20%
Supports
None
Notes
Print the jig top face down.

Hardware

  • 5/8" drill bit (or brad-point bit)
  • 4 × Optional 5/8" steel drill bushing

Assembly

  1. Press the stop bar's two pegs into the holes on the underside of the jig for the first corner position only.
  2. Hook the jig over the sheet's top and side edges, then drill holes 1–4.
  3. Move right: pins in the last two holes drilled, through guide holes 1 and 2. Drill holes 3 and 4.
  4. Next row: put a pin through the row-step hole into the first hole of the row above, set the side lip on the edge, and drill again.

Good to know

  • Not test-printed: print once and check that the pins slip in by hand with no slop. Adjust the Pin clearance slider if they don't.
  • Drill with a sharp bit and light pressure. The PLA guide holes will wear over 1,000+ holes, so press in a metal 5/8" bushing if you want it to last.
  • The sheet is assumed to be 1/4" thick. Change the Sheet thickness slider if it isn't.
  • The build report still shows a few small cosmetic ledges on the jig. They don't affect function.

Comments