From the Loftsmith community

6 mm steel L-bracket for driving light

Gives a driving light something solid to hang from. The base bolts down flat, the upright holds the light on its stud, and a separate flat strip comes with it. Change the bolt spacing and the upright height to match your mount.

2 parts · 72 g · 200 × 150 × 80 mm

by Brad Impact

Dark L-shaped steel bracket with bolt holes and a stud, beside a flat strip and a pale round light
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • bracket-folded · 6 mm mild steel (laser cut, press-brake

    Reference model for the fabricator. Do not 3D print.

  • flat-pattern · 6 mm mild steel (laser blank)

    199.6 × 60 mm blank with three holes. The etched line and notches mark the bend centre line, which is the 90° bend with the etched face on the outside.

Print settings

Notes
Not for 3D printing. This is a fabrication model for 6 mm mild steel.

Hardware

  • 2 × M10 bolts · Through the Ø10.5 base holes, to the bumper.
  • M12 stud with nut and washer · Through the Ø12.5 hole to hold the light.

Good to know

  • The K-factor of 0.44 is typical, not measured. Confirm it with your brake shop, because it moves the stud hole and bend line by a millimetre or so.
  • The strength check is a simple estimate: 2.5 kg light, 4 g shock, 60 mm lever. It isn't qualified. Adjust the light weight slider to match yours.
  • The viewer flags the etched bend line as thin ledges. It's deliberate, so remove it from the laser file if you don't want a scribe.
  • The flat pattern is shown as a 3D plate, not a DXF.

Comments