From the Loftsmith Workshop

Mower oil filter drain chute, fits 64-96 mm filters

Takes the mess out of pulling a mower oil filter. The collar slips around the filter and the chute tips the old oil down and away, so it runs into your pan instead of over your hands. Change the filter size and chute length to suit your mower.

1 part · 37 g · 89 × 105 × 154 mm

by Loftsmith Workshop

Orange ring collar with a long angled chute, sitting around a dark round filter
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • drain chute · PETG · Standing on the flat engine-side face of the collar, ring upright, chute leaning out at the chute angle (30° from vertical at the defaults). No supports.

    153.9 x 89.2 x 105.0 mm on the bed at the defaults; about 38 g and 1 h 3 min at 2 walls / 15% infill. PETG because it is handled near a warm engine and in contact with oil; PLA softens around 55 °C.

Print settings

Layer height
0.2 mm
Walls
2 (default figures: ~38 g, ~1 h 3 min). With 3 walls: ~52 g, ~1 h 27 min
Infill
15%
Supports
None
Notes
PETG. Print standing on the collar's engine-side face. The chute leans out at the chute angle (45° at most), so it builds without supports. A brim helps hold the narrow keel end down on the bed.

Assembly

  1. Measure the filter can's diameter with calipers and set Filter diameter to that number.
  2. Set Chute angle and Chute length so the spout ends past the frame rail and over your drain pan. At the defaults the outlet floor is 69 mm below the bottom of the filter and 98 mm out from the engine face.
  3. Before loosening the filter, slide the collar over the filter's outer end with the chute underneath. Push it toward the engine until it stops at the engine or filter mount.
  4. Put the pan under the spout and loosen the filter. Oil from the gasket drips into the collar floor, drops through the slot and runs down the chute.
  5. The collar only hangs on the filter, so it comes free when the filter does. As the filter spins off, hold the collar with your other hand, or let it drop into the pan along with the filter.
  6. Wipe the collar clean for next time.

Good to know

  • Made for filters that stick out roughly level from the engine. If your filter points down at an angle, subtract that tilt from the Chute angle when you judge the slope. It does not suit filters that hang straight down.
  • The collar is held only by hanging on the filter. Nothing holds it once the filter is off, so hold it or let it fall into the pan as the filter comes free.
  • It catches drips from the gasket while the filter is loosened and removed. It does not catch the oil left inside the filter when you tip it, so turn the filter over the pan.
  • PETG softens at about 75 °C. Let the engine cool until the oil is warm, not hot, before you fit the collar.
  • It is a slip fit, not a clamp. If it is loose on your filter, lower Rib clearance by 0.2 mm. If it binds, raise it.
  • The collar is 13.2 mm larger than the filter diameter, and the keel under it is deeper still. Check there is room around the filter before printing.
  • Fit, flow and strength are checked in the Loftsmith engine, not on a real mower. Printing a short collar first (Collar length 22 mm, Chute length 70 mm) is a cheap fit test.

Comments