From the Loftsmith community
Draining tray with click-in legs
A raised rack for things that need to drip dry, so they're not sitting in a puddle on the counter. The long slots let water run straight through, and the four legs click in, so it packs flat when you're not using it. Change the length and width to fit your sink side.
5 parts · 66 g · 240 × 66 × 79 mm
Loading the 3D view
Loading the 3D view
No adjustable sizes
Ask for the sizes you want to tweak, e.g. “make the width adjustable”.
How to print it
Parts
- tray · PLA · Floor down, flat on the bed
- leg ×4 · PLA · Lying on its flat side
Print settings
- Layer height
- 0.2 mm
- Walls
- 3
- Infill
- 15%
- Supports
- none
Good to know
- The click catch is a real step, so the leg report still lists it. Print one leg first to check the click.
- The sliders showed length 240, width 110, edge 18, leg 110, fit 0.5 and load 0.5 kg when you asked. The picture and numbers here use the saved defaults, so re-check the checks if you keep those slider values.
Comments