From the Loftsmith Workshop

Locking Christmas ornament hooks for 3-12 mm branches

Hangs an ornament from a branch and stays put when someone brushes past. The hook curls over the branch, and its slim stem ends in a small eye for the ornament loop. Set the branch thickness and how far the ornament drops.

12 parts · 11 g · 14 × 2 × 60 mm

by Loftsmith Workshop

Slim green hook curled over a round branch, with a small eye at the bottom end
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • hook ×12 · PETG · Flat on the bed (2.4 mm tall), no supports

    One piece: crook, spine, closed eye and spring gate. At default sizes each hook is 14.4 x 60.3 x 2.4 mm, about 1 g and about 5 min. The Hooks in the set slider sets the quantity (1-24). PETG is used because the gate has to bend about 6 mm (12 mm at the largest setting) and spring back without cracki

Print settings

Layer height
0.2 mm
Walls
2
Infill
15%
Supports
None
Notes
At default sizes the set of 12 takes about 11 g and 1 h 4 min (one hook is about 1 g, 5 min). The band is 1-4 mm wide, so it prints almost entirely as perimeters and extra walls or infill change little. Use dry PETG. If a string bridges the 0.45 mm gap between the gate tip and the nose, cut it so th

Hardware

  • 0 × Ribbon or thread for ornaments without their own loop · Optional. The eye has a 4.4 mm hole.

Assembly

  1. Measure the branch where the ornament will hang (calipers, or a ruler across the twig) and set Branch diameter to it. If the twig has thick needles or bumps, go up 1-2 mm.
  2. Print the set flat. Check that each gate tip moves freely next to the nose; cut any string in the gap.
  3. Attach the ornament to the eye. For a ribbon or thread loop, push the loop through the eye and pass the ornament through it (a lark's head knot). For a bauble with a spring-wire cap, pinch the wire out of the cap, slide one leg through the eye and push the wire back in.
  4. Hold the hook by its eye and press the gate against the branch just below the hook's nose. The gate swings in, the branch drops into the crook and the gate springs back shut.
  5. To take it off, press the gate tip inward with a fingertip and lift the hook off the branch.

Good to know

  • Not cat-proof. The hook stays on the branch, but it will not save a glass bauble that is knocked hard or a tree that falls over.
  • The gate's bending is calculated with a beam formula and kept under 70% of PETG's yield strain; it is not simulated, and the snap has not been tested on a real print. Print one hook and try it on your tree before printing the set.
  • The checks assume PETG. PLA is stiffer and more brittle, and the larger branch sizes may crack the gate.
  • On thin branches (3-4 mm) the gate is a very light spring: it closes, but the click is weak.
  • The checks cover ornaments from 10 g to 150 g (at three times their weight, for a yank). Heavier ornaments are not covered.
  • The eye is closed, so a wire bauble cap has to be slipped through as described in the steps, or hung with ribbon or thread.
  • At the largest sizes, 24 hooks may not fit on one 180 mm plate; split the set over two plates.

Comments