From the Loftsmith community

Stackable thermostat case

A tidy home for a DIY thermostat board, so the wiring stops living in a drawer. A clear lid sits over the circuit board and has a window for a small display, two round button holes and a few narrow slots. Change the length and width to match your board.

2 parts · 88 g · 160 × 72 × 35 mm

Long flat case with a dark base and a clear blue lid over a green circuit board, with two pins sticking out
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • case base · PLA · Floor down

    The groove under the base is a 45° dovetail, so it may need a little support.

  • case lid · PLA · Upside down, rails on the bed

    Print rails-down so they need no support.

Print settings

Layer height
0.2 mm
Walls
2-3
Infill
15%
Supports
Only a little under the base groove, if your slicer asks for it

Hardware

  • 2 × M3 countersunk screw plus M3 heat-set insert · One screw and one insert at each end of the lid.

Assembly

  1. Press the two cords down into the back slots.
  2. Fit the thermostat and outlet inside.
  3. Put the lid on and fasten it with the two M3 screws.
  4. To stack, slide another case's grooves onto these rails from the side.

Good to know

  • The size is estimated from your photo, so check it against your device and change it with the Length and Width sliders on Adjust.
  • The dovetail fit is untested. Print a short test section first and tune the Stack clearance slider on Adjust.
  • The outlet opening and cord slots are sized from typical values, so test-fit your own parts.

Comments