From the Loftsmith Workshop
8.8 in bar display desk stand, sized to your screen
Props a slim bar display upright on your desk so you can read it at a glance. Two small feet cradle the screen at a gentle backward lean, and each has a cut-out beside it. Set the screen's length and thickness to match yours.
2 parts · 30 g · 242 × 103 × 44 mm
Loading the 3D view
Loading the 3D view
No adjustable sizes
Ask for the sizes you want to tweak, e.g. “make the width adjustable”.
How to print it
Parts
- cradle-left · PLA · Lying on its flat outer end face (the side profile is the layer shape), no supports
43.8 x 103.2 x 20.4 mm at the defaults, about 15 g and 26 min at 2 walls / 15%. Gets the port window when Port end is set to left.
- cradle-right · PLA · Lying on its flat outer end face, no supports
Mirror of the left cradle, about 15 g and 26 min at 2 walls / 15%. Gets the port window at the default Port end (right).
Print settings
- Layer height
- 0.2 mm
- Walls
- 2 (the page default); 3 walls recommended for stiffer lips
- Infill
- 15%
- Supports
- None. Overhang is 0% in the print orientation.
- Notes
- Both cradles fit one plate, even on a 180 mm bed. The deepest cradle across the slider range is 139 mm. At 2 walls / 15% the pair takes about 31 g and 53 min. At the recommended 3 walls / 15% it takes about 41 g and 1 h 10 min. PLA is fine on a desk. Use PETG if the stand will sit somewhere warm.
Assembly
- Measure your screen's length, height and thickness, its narrowest bezel and which end its port is on. Weigh it on a kitchen scale. Set the sliders on the Adjust tab before you download.
- Print both cradles lying on their flat outer end faces.
- Stand the two cradles about one screen length apart, open sides facing each other.
- Lower the screen straight down along its tilt into both pockets until it sits on the shelves. The front lips cover only the bezel at each end and along the bottom edge.
- Plug the cable in through the window in the end wall and lead it back behind the stand.
Good to know
- The defaults use a 233 x 66 mm outline from one Amazon listing for an 8.8 in 1920x480 unit (amazon.com/dp/B0DFGRMZDP). I did not check that against a datasheet. The 12 mm thickness, 4 mm bezel and 180 g weight are assumptions. Outlines vary between makers, so measure yours and set the sliders.
- This is a fixed-tilt desk stand. There is no click-tilt hinge, monitor-top clip or fan-hole bracket.
- The port window fits one end port up to the opening length you set (sized for a USB-C plug body about 7 x 12 mm). It does not open the back or bottom, so ports behind the 16 mm grip zones will be covered.
- The base is sized so a 2 N press square on the top edge cannot tip it backwards (2.55 N at the defaults). A stiff or heavy cable pulling sideways or backwards, or a harder push, can still move or tip it. A dab of museum putty under the feet helps.
- The two cradles are separate parts held together only by the screen. Fit and stability were checked in the Loftsmith engine, not on a real print.
Comments