From the Loftsmith community

Shahiba two-drawer box

A little two-drawer box for the small things that end up scattered across a desk or shelf. Each drawer has a finger dip instead of a handle, and the name on the lid is carved in, so it's clearly yours. Change the drawer size to hold what you have.

4 parts · 274 g · 147 × 104 × 79 mm

Small two-drawer box with curved finger pulls and a name carved into the top
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • box · PLA · Lying on its back, drawer openings facing up

    No supports needed.

  • drawer-bottom · PLA · Open side up
  • drawer-top · PLA · Open side up

    Same shape as the bottom drawer.

  • letters · PLA (contrast colour) · Flat on the bed

    8 separate pieces (the dot of the i is its own piece).

Print settings

Layer height
0.2 mm
Walls
2
Infill
15%
Supports
None
Notes
Print the letters in a contrasting colour. A textured or smooth PEI plate both work.

Hardware

  • Super glue (CA) or PLA-safe glue · For gluing the letters into the carving

Assembly

  1. Remove any brim or elephant's foot from the drawer edges so they slide smoothly.
  2. Dry-fit each letter in the carving, then add a small drop of glue and press it in.
  3. Slide the drawers into their slots. Both drawers are the same, so either one fits either slot.

Good to know

  • The letters come off the printer as 8 separate pieces on purpose: you glue each one into its own spot in the carving, so they aren't joined together.
  • The drawers have no stop, so if you pull hard they come all the way out. I can add a small catch if you want one.
  • If the drawers feel tight or loose on your printer, change the Drawer side gap slider on the Adjust tab (it's set to 0.5 mm).

Comments