From the Loftsmith community

SYM Symphony 20ST cup holder

A place for your drink on the scooter instead of the footwell. The basket hangs off a clamp that wraps the handlebar, and slots in its sides let drips drain and keep it light. Change the basket width and depth to fit your own cup.

2 parts · 71 g · 89 × 156 × 86 mm

Black tapered cup basket with slotted sides, attached to a handlebar by a two-piece clamp
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • holder-body · PLA · Upright on the basket floor, no supports.
  • clamp-cap · PLA · Flat split face down.

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
None (optional for the cap bore)

Hardware

  • 2 × M4 x 16 socket screw
  • 2 × M4 heat-set insert · Melt into the lower clamp ears of the body.
  • Rubber or bike inner-tube strip · Optional: wrap the bar for extra grip.

Assembly

  1. Melt the two M4 inserts into the clamp ears on the body.
  2. Place the body under the bar and the cap on top.
  3. Tighten both M4 screws evenly.

Good to know

  • I couldn't check your scooter. I assumed a 22.2 mm tube and a clear spot with room for the cup. Measure the tube, and mind the mirror and your knees.
  • The analyzer still flags a few hairline ledges where the web meets the basket wall. They're cosmetic. The cap may also need about 1 g of support in the bore.
  • The checks are calculations, not tests. Try it with a full cup before riding, and add rubber tape if it turns on the bar.

Comments