From the Loftsmith community

Perforated click-lid box

A small box for things that like a little air, or that you just want to see are still there. The lid is covered in tiny round holes and presses on with a click, plus a notch at the front to get a fingertip under it. Change the length, width and height to fit what you're storing.

2 parts · 30 g · 80 × 40 × 30 mm

Shallow dark box with an orange lid full of small round holes and a finger notch at the front
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • box · PLA · Open side up

    No supports needed

  • lid · PLA · Top face down, lip pointing up

    No supports needed

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
None
Notes
Print both parts on one plate.

Assembly

  1. Press the lid straight down until you feel it click.
  2. To open it, put your thumb in the front notch and lift.

Good to know

  • The 'Every part has a way in' check and the Use it motion show the lid as blocked. That's on purpose: it's the 0.3 mm click bump squeezing past the rim. The lip bends that little bit and snaps into the groove, which is what makes it click.
  • How firmly it clicks depends on your printer. If it's too tight, set Lid lip clearance to 0.15; if it's too loose, raise Click strength to 0.5.
I printed this Remix

Comments