From the Loftsmith community

40-stamp tray, clean surface

Keeps a whole set of letter and number stamps standing upright and in order, so you can find the right one without tipping out a box. Forty square holes are in a tidy grid, each with its character etched underneath. Change the stamp width to match yours.

1 part · 131 g · 123 × 87 × 40 mm

by Steve

Flat tray with a grid of forty square holes, each holding an upright stamp, characters etched below
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • tray · PLA · Flat on its base, no supports

Print settings

Layer height
0.2 mm
Walls
2
Infill
15%
Supports
None
Notes
The tray stays upright when loaded.

Good to know

  • I guessed the 40 characters as A–Z, 0–9 and & . - /. Tell me if your set differs.
  • The report still flags a few thin ledges inside the engraved letters. They are cosmetic and don't affect the fit.
  • Test the fit by printing one row first. The Hole clearance slider on Adjust changes the fit if your stamps are slightly oversize.

Comments