From the Loftsmith community

NACS holder with Tesla-shaped port

Gives your EV charging plug somewhere to rest besides the garage floor. It's a wall plate with an angled pocket that cradles the plug nose, tipped so the plug sits at a slant. Change the nose width and head height to match your own plug.

1 part · 122 g · 96 × 98 × 157 mm

by jazid

Dark wall plate with an angled square pocket, shaped to hold a charging plug nose
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • holder · PLA · Back face flat on the bed, front facing up

    96 × 157 × 74 mm

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
Only if the slicer flags the underside of the tilted pocket
Notes
Print back face down.

Hardware

  • 2 × 4 mm countersunk wood screws with wall plugs · Pick the length for your wall. They sit 120 mm apart, one above and one below the pocket.

Assembly

  1. Mark two holes 120 mm apart, one above the other, and fit wall plugs.
  2. Screw the holder to the wall through the two countersunk holes.
  3. Lower the plug nose-down into the pocket until its shoulder rests on the rim.

Good to know

  • Plug nose size (46 × 28 mm) and shoulder width (60 mm) are estimates. Measure your plug and set the sliders on Adjust.
  • A small area under the tilted pocket may print with a little support. Fit and strength are calculated, not tested, so try it with your real plug.
I printed this Remix

Comments