From the Loftsmith community
Tube tie rail
Keeps a row of tubes lying neatly side by side instead of tangled together. Each one sits in its own cable tie slot along the rail, and the two screw holes at the ends let you fix it down. Change the number of tubes or the spacing to match your run.
1 part · 12 g · 138 × 20 × 10 mm
Loading the 3D view
Loading the 3D view
No adjustable sizes
Ask for the sizes you want to tweak, e.g. “make the width adjustable”.
How to print it
Parts
- rail · PLA · Mounting face down, flat on the bed
The grooves and slots on the underside are short bridges, so no supports are needed.
Print settings
- Layer height
- 0.2 mm
- Walls
- 3
- Infill
- 15%
- Supports
- None
Hardware
- 2 × M5 bolts, countersunk or flat head, with nuts · Size is a guess, so change it to match your bracket.
- 6 × Cable ties, about 4.8 x 1.2 mm · The slots are sized for this tie. Adjust the tie sliders if yours differ.
Good to know
- I guessed M5 bolts and 4.8 mm ties, so check them against your bracket and ties.
- Tube saddles have 0.3 mm play, so tighten the ties well. Do a quick test fit with a short rail first.
Comments