From the Loftsmith Workshop

Stacking Christmas bauble storage trays, 50-100 mm baubles

Gives each Christmas bauble its own little cup, so nothing rolls into anything else in the box. Every tray holds four cups with a notch at the rim for the cap and hanging loop, and the trays stack on corner posts. Set the bauble size and your tub's inside size to fit.

3 parts · 247 g · 152 × 152 × 95 mm

by Loftsmith Workshop

Three stacked green trays on four corner posts, each holding four round cups with a notch at the rim
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • tray ×3 · PLA · Flat on its base as modelled (columns up), no supports

    Quantity 3 is one stack: the number of layers that fit a 280 mm tall tub at the default sliders. A 500 x 350 mm tub takes 3 x 2 stacks (18 trays, 72 baubles). About 86 g and 2 h 5 min per tray at 2 walls and 15% infill. PLA is stiff enough for this light, room-temperature storage job.

Print settings

Layer height
0.2 mm
Walls
2
Infill
15%
Supports
None. The funnel undersides are 50° and the rim flares are steeper, so nothing overhangs past 45°.
Notes
One tray: about 86 g and 2 h 5 min. One stack of three (the default quantity): about 257 g and 6 h 15 min, all from the Loftsmith build estimate at 2 walls and 15% infill. With 3 walls and 15% infill a stack is about 357 g and 8 h 41 min; the load check does not need it. Each tray is a single 152 x

Assembly

  1. Print one tray per layer of your tub. The 'Trays fit the tub' check lists trays per layer and layers; at the defaults that is 3 x 2 stacks of 3 trays.
  2. Stand the first tray on the tub floor and lower each bauble cap-up into a cradle. It settles on the funnel ring, with its widest part just above the rim.
  3. Set the next tray on top: line its four column sockets up over the pins on the tray below and lower it straight down. Its weight goes through the columns, not the baubles.
  4. To unpack, lift the trays off from the top down. Then pinch each bauble at the two finger notches on its diagonals and lift it straight up.

Good to know

  • Checked in the Loftsmith engine only; nothing has been printed yet. Print one tray first and check one of your own baubles and caps in it before printing a whole tub.
  • Measure the bauble across its widest point and the cap plus loop from the top of the glass. The cap is modelled as up to 20 mm across. Unhook any metal ornament hooks before storing.
  • The cradles are for round baubles. Teardrop, star or figure ornaments will not seat on the funnel ring.
  • The column load check assumes 100 g per bauble and doubles it for setting a tray down. It does not cover sitting other boxes on top of a stack.
  • PLA softens at about 55 °C. Do not store the tub in a hot loft or a car; use PETG for that.
  • Filament adds up: a full 500 x 350 x 280 mm tub at the defaults is 18 trays, about 1.5 kg of PLA.
  • On a 180 mm bed, baubles over about 80 mm get one cell per tray; choose the 256 mm bed to keep 2 x 2 cells up to 100 mm.

Comments