From the Loftsmith community

Telescopic zoom barrel with twist-lock

A tube that slides out to length and locks there with a twist, handy for a homemade zoom lens, scope or viewer. The orange ring has a ridged edge that's easy to grip, and the opening runs straight through. Change the barrel width and length to suit your build.

2 parts · 44 g · 35 × 35 × 109 mm

Tall dark cylindrical tube with an orange ridged ring at the top and an open bore
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • outer-barrel · PLA · Standing upright, back end down

    The lug inside has a 45° underside, so no supports.

  • inner-tube · PLA · Grip ring down (flip 180°)

    Print with the grip ring on the bed.

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
None

Assembly

  1. Insert the inner tube from the front with the groove lined up on the lug.
  2. Twist 25° to lock, or untwist to slide it to the next stop.

Good to know

  • The fit, the friction and how the lug feels in the notches are untested, so print and try them. Adjust the Sliding fit slider if it is too tight or too loose.
  • The motion check is a rigid-body check only. It is not a dynamic simulation.

Comments