From the Loftsmith community

Thread fit test kit

Saves you reprinting a whole part just to find out the thread is too tight. The plate has a row of holes marked with different clearances, and a bolt and nut to try in them. Change the thread diameter and the clearance steps to match your own printer.

2 parts · 26 g · 126 × 40 × 26 mm

Dark plate with four numbered holes and an orange bolt, beside a clamp arm and a small knurled nut
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • nut strip · PLA · Flat, numbers facing up
  • test bolt · PLA · Knob down, thread pointing up

Print settings

Layer height
0.16-0.2 mm
Walls
3
Infill
15%
Supports
None expected; the thread flanks are the only overhangs

Good to know

  • I haven't had your result from a printed test yet. Tell me which nut turned freely and your measured thread diameter and pitch, then I'll lock those in. Until then I'm treating the fit as unconfirmed.
  • The 2.5 mm pitch is my estimate. You can set it on the Adjust tab.
  • The report still shows a small side ledge near the label and some thread-flank overhangs. Slice it first to check for visible marks.

Comments