From the Loftsmith community

LED channel + diffuser, straight and corner pieces

A tidy home for an LED strip under a shelf or along a cabinet edge. The strip sits in a U-shaped channel, and a snap-on cover with a honeycomb of small holes softens the glow. Set the strip width and channel length to match yours.

2 parts · 16 g · 150 × 18 × 14 mm

Long narrow U-channel with a flat cover pierced by rows of small hexagonal holes
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • channel · PLA · On its back, no supports

    Two countersunk M3 screw holes in the floor.

  • diffuser · PLA · Roof-down, no supports

    White or natural PLA glows best.

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
None

Hardware

  • 2 × M3 countersunk screws · For mounting each channel piece.

Assembly

  1. Slide the LED strip into the channel from the end.
  2. Screw the channel down with the two M3 screws.
  3. Press the diffuser straight down until it clicks onto the grooves.

Good to know

  • The corner piece hasn't been viewed or checked as the straight one has. Print a small test corner first.
  • A flat LED strip only bends sideways at a radius of about 40 mm or more. For tighter corners, cut the strip and bridge it with a short wire.
  • The snap fit uses a 0.4 mm bead in PLA. Check how it grips on your printer, and adjust the Clip clearance slider if it is too loose or too tight.

Comments