From the Loftsmith Workshop

Hanukkah menorah for LED tea lights and LED candles

A Hanukkah menorah that holds eight LED tea lights or LED candles in a row, with the shamash raised on its own little pedestal in the middle. No flames, so it's easy to set out anywhere. Change the cup size to match your lights.

3 parts · 154 g · 469 × 69 × 58 mm

by Loftsmith Workshop

Long flat menorah with eight round cups in a row and one raised cup on a pedestal in the middle
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • base-left · PLA · Flat on its base as modelled, no supports

    158 x 61 x 23 mm, about 47 g and 68 min at 2 walls/15%. Three cups; its open-bottomed dovetail slot lowers onto the centre piece.

  • base-centre · PLA · Flat on its base as modelled, no supports

    169 x 69 x 58 mm, about 60 g and 87 min at 2 walls/15%. Carries the raised shamash and both dovetail tenons.

  • base-right · PLA · Flat on its base as modelled, no supports

    158 x 61 x 23 mm, about 47 g and 68 min at 2 walls/15%. Mirror of base-left.

Print settings

Layer height
0.2 mm
Walls
2
Infill
15%
Supports
None
Notes
PLA is stiff and easy, and LED lights stay cool, so heat isn't a concern. At 2 walls and 15% infill the set is about 158 g and 3 h 48 min in total (47 + 60 + 47 g). With 3 walls and 15% infill for firmer cup rims it is about 198 g and 4 h 45 min. A silk gold or brass-coloured PLA gives the tradition

Hardware

  • 9 × LED tea lights, 38 mm diameter x 16 mm tall (or LED candles 15-40 mm across, set on the sliders) · Battery LED lights only, never real flames. Measure the diameter of yours and set Light diameter; the default light weight is an assumed 12 g each.

Assembly

  1. Set base-centre (the piece with the raised shamash) on the table.
  2. Hold base-left above its spot and lower it straight down so the slot under its inner end drops over the centre piece's dovetail. The tops sit flush.
  3. Do the same with base-right on the other side.
  4. Put the eight LED lights in the level cups and the shamash light in the raised centre cup.
  5. To move it, lift it by the centre piece: the end pieces hang on the dovetails. A drop of glue in each slot makes it permanent; without glue it comes apart for flat storage.

Good to know

  • For battery LED lights only. Never use real candles or tea lights: PLA softens at about 55 °C and burns.
  • LED tea lights and candles vary. Measure yours and set Light diameter. If the fit is tight or loose, adjust Cup clearance (0.4-2 mm).
  • The tip checks use an assumed light weight (12 g at the defaults, set with the Weight of one light slider) and an estimated printed base weight. They are engine estimates, not a physical test.
  • The dovetails lock the pieces along the row, but only gravity holds them down. Lift it by the centre piece; lifting by an end piece lifts that piece off.
  • The cups hold half of each light's height (8-25 mm deep). Very tall candles over 200 mm are best kept away from edges and pets.
  • The arched option is a gentle curve seen from above. Some traditions prefer the lights in a straight row, which is the default.

Comments