From the Loftsmith community

4" FPV prop guard (arc)

Keeps a spinning 4 inch prop from clipping the wall, a branch or your fingers. A thin curved band wraps about half the prop's edge and hangs off a three-spoke frame that bolts to the arm. Change the arc, the hole spacing and the clearance to match your own quad.

4 parts · 67 g · 95 × 117 × 29 mm

Curved orange guard band on a three-spoke frame with two bolt holes, wrapped around half a prop
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • prop-guard ×4 · PETG

    Print flat, tab side down. One per arm.

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
None
Notes
Print flat with the tab down. The band wall is 1.6 mm.

Hardware

  • 8 × M3 screws (or M2/M2.5 via the Screw size choice), length = arm thickness + 3.5 mm + a few mm for a nut or tapped hole · Two per guard

Good to know

  • I guessed that the hole midpoint is 26 mm from the motor centre and the prop is 20 mm above the arm's underside. Measure yours and set the sliders before printing all four.
  • The guard is the same part on all four arms. Your frame may need a mirrored version for some arms (the arc should face outward).
  • Tiny edge overhangs of about 1 g may show up; the part should print without supports. No physical crash test has been done.

Comments