From the Loftsmith community

Tapered bar hard case (sketch look)

A hard shell for carrying one tapered bar, the kind with a ball at one end and a long stem, so it stops rattling around your bag. It comes in four parts with a cushion lining inside. Change the ball size and stem length to match yours.

4 parts · 142 g · 188 × 56 × 56 mm

Long narrow hard case for a ball-ended bar, shown in four panels on a black background
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • shell-top · PLA · Split face down

    Magnet pockets and pin holes are in the split face; the thumb notch is on the side.

  • shell-bottom · PLA · Split face down
  • liner-top · TPU 95A · Flat face down
  • liner-bottom · TPU 95A · Flat face down

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
None needed unless the cavity ceiling sags; use light supports if it does
Notes
Print the TPU liner slowly.

Hardware

  • 6 × Magnet 6x3 mm · 3 per shell half, glue in with opposite poles facing
  • 4 × 1.75 mm filament pin, about 8 mm long · Offcuts of filament; they line up the halves

Assembly

  1. Glue the magnets into the pockets with opposite poles facing, then put the filament pins in the bottom half.
  2. Press the TPU liner halves into the shell halves.
  3. Lay the object in the bottom half and close the top; use the thumb notch to open it.

Good to know

  • The analyzer still reports about 4 g of support per shell half, from the sloped ceilings of the cavity; they are short and should print, but turn on light supports if the ceiling sags.
  • I assumed the 120 mm is the stem length beyond the sphere; change the Stem length slider if it includes the sphere. The 60 g object weight is a guess.
  • The drop check is an estimate and the magnets and TPU fit are untested, so print the liner first and check the sphere sits snugly.

Comments