From the Loftsmith community

Getwiste lantaarn voor LED-waxinelicht

A little lantern that turns an LED tealight into a patch of dotted light on the wall. The shade has a gentle twist and is covered in small teardrop holes, and it sits on a dark round base. Change the tealight size to match yours.

2 parts · 99 g · 96 × 96 × 134 mm

Twisted, ribbed lantern shade covered in small teardrop holes, resting on a dark round base
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • shade · PLA (wit of naturel) · Rechtop, de wijde onderkant op het bed

    Lichte PLA laat de kap mooi gloeien.

  • base · PLA (donker) · Rechtop, de platte onderkant op het bed

Print settings

Layer height
0,2 mm
Walls
2
Infill
15%
Supports
Geen
Notes
Print de kap met 'spiral/vase' uit: de gaatjes hebben gewone wanden nodig.

Hardware

  • LED-waxinelichtje (flikkerend) · Ca. Ø 38 mm. Is het jouwe anders, stel dan de schuifregelaar 'Lichtje Ø' in op Adjust.

Assembly

  1. Zet het LED-lichtje aan en leg het in het kuiltje van de voet.
  2. Zet de kap over het lichtje: de rand op de voet zet hem vanzelf recht.

Good to know

  • Ik ben uitgegaan van een lichtje van Ø 38 mm. Meet het jouwe even na, of print eerst alleen de voet om te kijken of het past.
  • De speling tussen kap en voet is 0,4 mm. Zit hij te strak of te los, verander dan de regelaar 'Speling kap/voet'.

Comments