From the Loftsmith community

Twisted river-stone AirPods 4 case

A pebble-shaped shell for your AirPods 4 charging case, so it feels like something smooth from a riverbank in your pocket. The lid lifts off the base at one seam, and a small round hole sits on the front. Change the case size and clearance to dial in the fit.

2 parts · 20 g · 58 × 31 × 55 mm

Rounded pebble-shaped case in two tones, with a lift-off lid and a small round hole on the front
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • sleeve · PLA · Upright, floor on the bed

    Has a scoop at the back so the lid can open 100°.

  • lid-cap · PLA · Upside down on its flat top

    Glue it to the lid with thin double-sided tape.

Print settings

Layer height
0.2 mm
Walls
2
Infill
15%
Supports
None
Notes
Slow down the outer walls for clean ridges.

Assembly

  1. Put the cap on the AirPods lid, with a small piece of double-sided tape on the lid if you want it held.
  2. Slide the AirPods straight down into the sleeve until the floor stops them.

Good to know

  • Print the sleeve first and check the AirPods slide in snugly; raise or lower the Fit clearance slider if it's too tight or loose.
  • The case dimensions are typical values I assumed, not measurements, so check them against yours.
  • The ridges and the hinge scoop leave a few short overhangs. The report flags them but estimates no support material, so test print one first.

Comments