From the Loftsmith community

Gridfinity syringe & bottle caddy (upright)

Keeps syringes standing upright and small bottles from rolling off the bench. Each syringe drops into its own slot with the wings resting on top and the plunger hanging down through a hole. Change the barrel and bottle sizes to match what you use.

1 part · 107 g · 126 × 84 × 86 mm

Green tray with five tall syringe slots divided by thin walls and three round bottle pockets in front
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • caddy · PLA · Upright on its Gridfinity feet

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
None

Good to know

  • Wing span (30 and 38 mm), wing thickness (2 mm) and plunger hole (12 mm) are guesses. Please measure your syringe wings and set the sliders on the Adjust tab.
  • Use a small test print first. Print just one wing pocket or the whole thing at 2 walls. Check that a syringe drops in and sits level, and tell me if it is tight or loose.
  • The report still shows a few thin ledges on the Gridfinity foot slopes, plus a small amount of overhang from the pocket edges. Both are cosmetic and should print without supports.
  • In the check of the lift-out path, only about half the poses were sampled. The rest is not verified.
I printed this Remix

Comments