From the Loftsmith community

Death Star Blink camera housing

Gives a Blink camera a much better disguise than a plain white box. It's a two-part ball with a seam around the middle, and two round openings on the front let the lens and motion sensor see out. Change the camera size and clearance to match your own.

2 parts · 191 g · 120 × 118 × 120 mm

Grey ball with a seam around the middle and two round openings on the front
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • bottom half · PLA · Split face down
  • top half · PLA · Split face down

Print settings

Layer height
0.2 mm
Walls
2-3
Infill
15%
Supports
Only if the slicer asks, for the lens and sensor openings

Hardware

  • 4 × M3 screw, about 12 mm · socket head, from underneath
  • 4 × M3 heat-set insert · into the top half's split face

Assembly

  1. Lay the camera into the bottom half.
  2. Lower the top half over it.
  3. Melt the M3 inserts into the top half, then drive the four screws up from underneath.
  4. Fit your wall mount through the back hole.

Good to know

  • Camera size and lens/sensor heights are estimated, so test-fit the openings against your camera and adjust the sliders.
  • The slicer may flag small overhangs at the camera pocket roof and the shallow panel grooves; a little tree support may be needed.
I printed this Remix

Comments