From the Loftsmith community

Socket holder, hidden dovetails + magnets

Gives every socket in your set its own hole, in order from small to large, so you can spot a missing one at a glance. It's built in three pieces that join with hidden dovetails, with pockets for magnets. Set the smallest and largest socket sizes to match your set.

3 parts · 167 g · 482 × 69 × 19 mm

Long flat tray in three joined sections, red ends and a dark middle, with two rows of round socket holes
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • short-row-left · PLA · Flat, bottom down
  • short-row-middle · PLA · Flat, bottom down
  • short-row-right · PLA · Flat, bottom down
  • deep-row-left · PLA · Flat, bottom down
  • deep-row-middle · PLA · Flat, bottom down
  • deep-row-right · PLA · Flat, bottom down

Print settings

Layer height
0.2 mm
Walls
2
Infill
15%
Supports
None
Notes
Print flat, bottom down.

Assembly

  1. Lay the left sections down.
  2. Lower each middle section straight down onto the left one so the dovetails engage.
  3. Lower each right section straight down onto the middle one.

Good to know

  • Socket sizes are guesses, so check the sliders against your sockets.
  • The dovetail fit (0.25 mm per side) hasn't been test printed. Print one joint first and use the Dovetail clearance slider to adjust it.
  • The report still flags one small 0.67 mm ledge on each left section near the joint. It's cosmetic, and you can sand it off.
  • I read 'single row' as one line of 18 per socket type. Tell me if you meant something else.
I printed this Remix

Comments