From the Loftsmith community

3.8" backflow-proof vent Y

Joins two vent runs into one duct and keeps air from sneaking back the way it came. Each branch has a little flap inside, and a small arrow on the body shows which way the air should flow. Change the duct size to match your pipe.

7 parts · 266 g · 224 × 99 × 242 mm

Y-shaped duct fitting with two angled branches, each with a round flap inside, and one outlet at the base
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • wye-body · PLA · Standing on the outlet, no supports
  • hinge-pin-right · PLA (or 3 mm steel rod) · Lying flat
  • hinge-pin-left · PLA (or 3 mm steel rod) · Lying flat
  • flap-right-a · PLA · Flat face down
  • flap-right-b · PLA · Flat face down
  • flap-left-a · PLA · Flat face down
  • flap-left-b · PLA · Flat face down

Print settings

Layer height
0.2 mm
Walls
2
Infill
15%
Supports
None
Notes
Body upright on the outlet; flaps flat face down. Use PETG if the vent gets warm.

Assembly

  1. Print everything.
  2. Slide each pair of flaps into the inlet and line up the hinge knuckles.
  3. Push a pin through the side holes and the knuckles.
  4. Slip the ducts over the ends. The duct covers the pin ends and holds them in.

Good to know

  • The surface check still reports 4 small ledges (0.6 mm wide, 6 mm long) at the sides of the crotch. Two fixes didn't remove them, and the second one was too heavy to build. They are cosmetic and should show as faint lines.
  • The flap motion and the assembly order were only partly checked by the software. Test-fit one flap before printing the rest.
  • The flaps are a lip seal, not airtight. Measure the inside of your duct and adjust the Duct size slider.

Comments