From the Loftsmith community

K2 SE poop chute

Sends purge waste down and away from the printer instead of letting it pile up where it lands. A flat flange with two screw holes holds it to the panel, and a rectangular channel bends downward into a slide. Change the slide angle and length to suit your setup.

1 part · 50 g · 98 × 117 × 102 mm

Blue rectangular chute with a screw flange at one end, bending down into a slanted slide
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio
I printed this Remix

Comments