From the Loftsmith community

Jagged rock aquarium background

Hides the tank wall behind a craggy cliff, so the back of your aquarium looks like rock instead of a bare pane. It comes in tiles that stack and slot together, which keeps each piece small. Change the width and how deep the rock sticks out.

8 parts · 1530 g · 270 × 90 × 420 mm

by BAS

Tall slab of rough, jagged brown rock with a flat plate along the back
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • base-left ×2 · PLA

    One per level at the default of two levels. Print flat on its back with the rock face up.

  • base-right ×2 · PLA

    One per level at the default of two levels. Print flat on its back with the rock face up.

  • stack-key ×2 · PLA

    One for each seam between levels at the default. Slide it in from the side.

  • top-left · PLA

    Print flat on its back.

  • top-right · PLA

    Print flat on its back. The slicer may add a little support under a few rock ledges.

Print settings

Layer height
0.2 mm
Walls
2
Infill
15%
Supports
None needed. A little may be added under a few ledges on top-right.
Notes
Print each tile lying on its back with the rock face up.

Assembly

  1. Stand the first base-left and base-right tiles side by side against the glass.
  2. Slide a stack-key into the facing top slots of the two tiles, from the side. Add a dab of glue if you like.
  3. Put the next base tiles on top. Their bottom slots drop onto the keys. Repeat for more levels.
  4. Lower top-left and top-right onto the top slot. They bridge the base seam.

Good to know

  • The tiles are big, and the whole set is about 1.2 kg of PLA, roughly 27 hours for everything at 2 walls and 15% infill. Print the tiles one at a time.
  • top-right has about 3% of its rock ledges overhanging, so the slicer may add about 3 g of support. The other tiles print without supports.
  • The slot clearance is 0.25 mm per side. Print one stack-key and test it in a base slot first, and tune the Slot clearance slider if it's too tight or too loose.
  • The slots and keys are untested physically, and the set isn't designed to carry weight. I haven't tested it in water. PLA softens at about 55 °C, so PETG is safer in a warm tank.

Comments