From the Loftsmith community

Select Therapy cone

A small cone with a hole through the top and the words Select Therapy raised on the side. Set it on a desk or shelf where people can see the name, or use the opening for something thin to pass through. Resize the height and the top hole to suit.

1 part · 13 g · 50 × 50 × 51 mm

Blue cone with a round hole in the top and raised Select Therapy lettering on its side
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • cone · PLA · Standing on its wide open end, no supports

Print settings

Layer height
0.12–0.16 mm (finer layers make the letters crisper)
Walls
3
Infill
15%
Supports
None
Notes
Print upright on the wide end. For a two-colour logo on a one-colour printer, the letters run up the side, so a single pause won't do it. Paint the raised letters after printing instead.

Good to know

  • The 2 in height is my guess. If you want it taller or shorter, use the Height slider before you print.
  • The tops of the raised letters are tiny flat ledges on the slanted wall. That's normal for raised lettering and prints fine, especially with finer layers.
  • This uses real lettering in a bold font, not your actual Select Therapy logo artwork. Send me a picture of the logo and I can put that on instead.
I printed this Remix

Comments