From the Loftsmith Workshop

Reusable Christmas cracker with click for 20-45 mm gifts

A Christmas cracker you can fill again every year, with room inside for a small gift. The red middle pulls apart with a click, and the twisted yellow ends are made to be pulled. Change the gift size and how firmly it holds to suit your present.

4 parts · 75 g · 177 × 56 × 57 mm

by Loftsmith Workshop

Red candy-shaped Christmas cracker with a seam in the middle and twisted yellow ends
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Parts

  • left half (spigot) · PETG · Standing on its cap end, spigot up

    About 20 g, 36 min at defaults. Carries the short click ridge the teeth ride over.

  • right half (click socket) · PETG · Mouth down on the bed

    About 18 g, 32 min at defaults. Five curved spring arms (default) stand on the bed so they bend within their layers, not across them.

  • end cap left · PETG · Flare down

    About 18 g, 31 min at defaults. Three twist lugs on the spigot.

  • end cap right · PETG · Flare down

    Same shape as the left cap; print two of either.

Print settings

Layer height
0.2 mm
Walls
2
Infill
15%
Supports
None
Notes
PETG because the spring arms flex on every pull and PETG takes repeated bending better than PLA. About 77 g and 2 h 16 min for all four parts at 2 walls / 15% infill (build report estimate). The largest part at defaults is 57 mm across and 66 mm tall, so all four fit a 180 mm bed together.

Assembly

  1. Drop the gift into either half (it slides through the left half's spigot).
  2. Push the right half onto the left half's spigot until the teeth click over the ridge and the seam closes.
  3. Fit each end cap: line its three lugs up with the three gaps in the tube end, push it in, and turn it clockwise (looking at the end) about a sixth of a turn until it stops.
  4. To use: two people each hold a flared end and pull. The halves click apart and the gift is inside.
  5. To refill: twist an end cap back a sixth of a turn and lift it off, or push the two halves back together until they click.

Good to know

  • Small parts: the caps and whatever gift you put inside can be a choking hazard. Not for children under 3, and supervise young children.
  • There is no bang. The pull ends in a printed click, not a snap strip.
  • The pull-apart force is a textbook estimate (cantilever arms, friction 0.3, PETG stiffness 2000 MPa). The teeth overlap the ridge by only 0.6 mm, so normal print tolerance can change the real force noticeably. Print the two halves and try the pull before printing a whole set.
  • Spring arm stress is checked against PETG's allowable for bending within the layers. PLA is stiffer and more brittle, so the force and how long the arms last will differ if you print in PLA.
  • The twist caps have hard stops but no click. A firm twist in the opening direction will loosen them.
  • Gift sizes are the slider range only: 20-45 mm diameter, 50-130 mm length, with 0.6 mm radial clearance at the narrowest bore.

Comments