From the Loftsmith community

JBL SoundGear Sense case cover

A snug cover that wraps the JBL SoundGear Sense charging case so it stops getting scuffed in your bag. The top has fine ridges for grip, there's a cut-out for the USB-C port, and a finger notch on the front helps you open the lid. Change the case length and height to match yours.

3 parts · 28 g · 109 × 135 × 30 mm

Rounded two-tone case cover with a ridged orange top, blue finger notch, and a separate grey ring beside it
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • fit-test-ring · PLA · Flat on the bed

    Print first. Slide it over the middle of your closed case.

  • cover-bottom · PLA · Open side up
  • cover-lid · PLA · Flipped, top face down

Print settings

Layer height
0.2 mm
Walls
3
Infill
15%
Supports
None or a little; check the slicer preview

Good to know

  • The fit isn't confirmed on your case. You said an earlier print fit, but I haven't had a measured size. Print the test ring and tell me if it's tight or loose.
  • The case height (30 mm) and seam height (20 mm) are estimates from photos.
  • The slicer may add about 1 g of support per shell at the rounded edges.
I printed this Remix

Comments