From the Loftsmith community

Chirpy cone-top cylinder 83 mm (copy)

A little pencil-shaped pod with the name Chirpy raised along its side, so it's easy to spot and easy to hold. There's a tiny hole through the tip and a shallow hollow underneath. Change the height, width or cone length to suit.

1 part · 18 g · 33 × 32 × 83 mm

Yellow cylinder with a cone top and a small hole at the tip, with raised lettering down one side
Loading the 3D view
Loading the 3D view
No adjustable sizes

Ask for the sizes you want to tweak, e.g. “make the width adjustable”.

Change it in the Studio

Parts

  • cylinder · PLA · Standing upright, hollow side down on the bed

    No supports needed

Print settings

Layer height
0.16 mm (crisper letters)
Walls
3
Infill
15%
Supports
None
Notes
Print upright.

Good to know

  • The print report flags the undersides of the raised letters as small ledges, the same as on the 62 mm version. That's normal for raised lettering on an upright wall and prints fine at 0.8 mm.
  • Your 62 mm version is unchanged. Moving the Total height slider on the Adjust tab switches between the two sizes.
I printed this Remix

Comments